Product details:

Single row tapered roller bearings are designed to accommodate combined loads, i.e. simultaneously acting radial and axial loads. The projection lines of the raceways meet at a common point on the bearing axis to provide a true rolling action and therefore low frictional moments during operation. The axial load carrying capacity of tapered roller bearings increases with increasing contact angle. Features Low friction The optimized roller end design and surface finish on the flange promote lubricant film formation, resulting in lower friction. This also reduces frictional heat and flange wear. In addition, the bearings can better maintain preload and run at reduced noise levels. Enhanced operational reliability Optimized surface finish on the contact surfaces of the rollers and raceways supports the formation of a hydrodynamic lubricant film. Rigid bearing application A single row tapered roller bearing is typically adjusted against a second tapered roller bearing. By applying a preload, a rigid bearing application can be achieved. Separable and interchangeable The inner ring with roller and cage assembly (cone) can be mounted separately from the outer ring (cup). Furthermore, the separable components are interchangeable. This facilitates mounting, dismounting and also maintenance inspection routines. Specifications Unit system: Metric. Bore diameter d: 55mm. Outside diameter D: 100mm. Total bearing width T: 26.75mm. Inner ring shoulder diameter d1: 75.33mm. Width inner ring B: 25mm. Width outer ring C: 21mm. Corner radius inner ring r1,2min: 2mm. Corner radius outer ring r3,4min: 1.5mm. Distance pressure point a: 22mm. Abutment diameter shaft damax: 64mm. Abutment diameter shaft dbmin: 65mm. Abutment diameter housing Damin: 87mm. Abutment diameter housing Damax: 92mm. Abutment diameter housing Dbmin: 95mm. Abutment housing - axial space at the large side face/ both sides of the outer ring Camin: 4mm. Abutment housing - axial space at the small side face/ both sides of the outer ring Cbmin: 5.5mm. Fillet radius ra